Frio LED Remote Controller for 9 Can and/or 18 Can softside coolers.
- Turns On/Standby -Press this key to turn on unit or switch to standby mode. At power on, unit will automatically turn on and restore to precious status. Dynamic mode Adjust -Switch to dynamic mode from static color, or switch between dynamic modes. Dynamic Speed Adjust -Adjust dynamic playing speed. Press SPEED+ to increase speed and press SPEED- to decrease. Unit will switch to dynamic mode if press this key at static color mode. Static Color Adjust -Switch to static color mode from dynamic mode, or switch between static colors. Direct Color Select -Shortcut key to static colors. When press the specific color key, LED will play the same static color. The direct colors are included in 'COLOR+' and 'COLOR-; operation. Brightness Adjust -Adjust static color brightness. Press BRIGHT+ to increase brightness and press BRIGHT- to decrease. Unit will switch to static color mode if press this key at dynamic mode. Demo Mode -Press this key will switch to Demo mode. At Demo mode, it plays 17 dynamic modes in loop, each mode repeat 3 times.
- Power Supply -This unit accepts DC 5V to 24V power supply. The DC jack's inner pole (or red cable) is positive and sleeve (or black cable) is negative. Also please make sure the power supply voltage is same as the LED load. LED Output -This unit support common anode connection LED products. The mark + indicates the common connection node.
- Using Remote Controller -Please pull out the battery insulate tape before using. The RF wireless remote signal can pass through barrier, so it's not necessary to aim at the main unit when operate. Pairing New Remote -The remote and main unit is 1 to 1 paired as default. Further more, main unit can be paired to 3 remote controllers and each remote controller can be paired to any main unit. Plead to following steps to pair new remote controller: Plug off the power of main unit and plug in after 5 seconds. Press 'SPEED-' and 'SPEED+' key together in 5 seconds after power on. After this operation the main unit will recognize the new remote controller. Free Remote Pairing Mode -In some specific cases; the main unit may need to be paired to any remote controllers. Please do following steps for free remote paring mode: Plug off the power of main unit and plug in after 5 Seconds. Press 'ON/OFF' and 'MODE+' key together in 5 seconds after power on. After this operation, the main unit will recognize any remote controller. To pair the main unit back to specific remote, please repeat the 'Pairing New Remote' operation. Switch Output Color Sequence: -The controller's default output signal sequence is Common-Gree-Red-Blue. If the LED application is in different cable sequence, the direct color keys will not match the LED color. In this case user can adjust the output signal sequence with following steps: Plug off the power of main unit and plug in after 5 seconds. Press 'RED' and 'BLUE' color key together in 5 seconds after power on. With this operation, the output sequence will switch between 6 possible combinations. The sequence will be memorized and it won't change before next same operations.